Allied Telesis AT-S62 - Manual (Page 134)

Chapter 11: Event Log and Syslog Servers
134 Section II: Advanced Operations
Modifying a
Syslog Server
Definition
To modify a syslog server definition, perform the following procedure:
1. From the Home Page, click Configuration.
2. Select the System menu selection.
3. Select the Event Log tab.
The Event Log tab is shown in Figure 29 on page 123.
4. In the Current Log Outputs section of the tab, click the syslog entry you
want to modify and click Modify.
The Modify Event Log Output window for the selected syslog definition
is displayed.
5. Configure the parameter settings as needed. For descriptions of the
parameters, refer to “Creating a Syslog Server Definition” on
page 130.
6. After you finish configuring the parameters, click Apply.
Changes to a syslog definition are immediately activated on the
switch.
7. To permanently save the change, click the Save Config menu
selection.
Deleting a Syslog
Server Definition
To delete a syslog server definition, perform the following procedure:
1. From the Home Page, click Configuration.
2. Select the System menu option.
3. Select the Event Log tab.
The Event Log tab is shown in Figure 29 on page 123.
4. In the Current Log Outputs section of the tab, click the syslog definition
you want to delete and click Delete.
The selected syslog definition is immediately deleted from the switch.
5. To permanently save the change, click the Save Config menu
selection.