Allied Telesis AT-S62 - Manual (Page 242)

Chapter 19: SNMPv3
242 Section III: SNMPv3
changes to a Target Address Table entry with a Volatile storage type,
the Save Config menu selection does not appear.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Address Table to the configuration file. After making changes to
a Target Address Table entry with a NonVolatile storage type, the Save
Config menu selection appears.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Target Address Table entry
takes effect immediately.
14. Click Apply to update the SNMPv3 Target Address Table.
15. To save your changes, select the Save Config menu selection.
Deleting a Target
Address Table
Entry
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the page.
The SNMPv3 Target Address Table Page is shown in Figure 74 on
page 240.
5. Display the SNMPv3 Target Address Table entry that you want to
delete.
Click Next or Previous to display an entry.
6. Click Remove.
A warning message is displayed. Click OK to remove the Target
Address Table entry.
7. To save your changes, select the Save Config menu selection.