Allied Telesis AT-S62 - Manual (Page 113)

AT-S62 Management Sofwatre Web Browser Interface User’s Guide
Section II: Advanced Operations 113
The File System tab is shown in Figure 27.
Figure 27. File System Tab
The information in the tab is defined below:
Current Drive
Specifies the location of the file system. The AT-8500 Series switch
has just one file system, located in flash memory. This will always
indicate Flash. This cannot be changed.
Default Configuration File
Specifies the filename of the active configuration file. The switch uses
this file to configure its operating parameters when it is reset or power
cycled. The active boot file is also the file that is updated when you
select the Save Config option.
Current Files
Lists the files stored in the file system. The columns are defined here:
File Name - The name of the system file.
Device - The storage location of the file. This column will be empty for
all files on an AT-8500 Series switch.
Size - The size of the file in kilobytes.
Modified - The date the file was created or last modified.