Allied Telesis AT-S62 - Manual (Page 231)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 231
ˆ defaultV1GroupReadWrite
ˆ defaultV2cGroupReadOnly
ˆ defaultV2cGroupReadWrite
9. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the SecurityToGroup Table to the configuration file. After making
changes to a SecurityToGroup Table entry with a Volatile storage type,
the Save Config menu selection does not appear.
NonVolatile
Select this storage type if you want the ability to save an entry in the
SecurityToGroup Table to the configuration file. After making changes
to a SecurityToGroup Table entry with a NonVolatile storage type, the
Save Config menu selection appears.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 SecurityToGroup Table
entry takes effect immediately.
10. Click Apply to update the SNMPv3 SecurityToGroup Table.
11. To save your changes, select the Save Config menu selection.
Deleting a
SecurityToGroup
Table Entry
To delete an entry SNMPv3 SecurityToGroup Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 68 on
page 229.
5. Click the circle next to the SecurityToGroup Table entry that you want
to delete. Then click Remove.