Allied Telesis AT-S62 - Manual (Page 230)

Chapter 19: SNMPv3
230 Section III: SNMPv3
5. To create an SNMPv3 SecurityToGroup Table entry, click Add.
The Add New SNMPv3 SecurityToGroup Page is shown in Figure 69.
Figure 69. Add New SNMPv3 SecurityToGroup Page
6. In the Security Model field, select the SNMP protocol that was
configured for this User Name.
Choose from the following:
v1
Select this value to associate the User Name with the SNMPv1
protocol.
v2c
Select this value to associate the User Name with the SNMPv2c
protocol.
v3
Select this value to associate the User Name with the SNMPv3
protocol.
7. In the Security Name field, enter the User Name that you want to
associate with a group.
Enter a User Name that you configured in “Creating a User Table
Entry” on page 208.
8. In the Group Name field, enter a Group Name that you configured in
the Access Table.
See “Creating an Access Table” on page 221.
There are four default values for this field that are reserved for
SNMPv1 and SNMPv2c implementations:
ˆ defaultV1GroupReadOnly