Allied Telesis AT-S62 - Manual (Page 150)

Chapter 13: Access Control Lists
150 Section II: Advanced Operations
Action
Use this menu to specify the action of the ACL. Deny, which is the
default, discards ingress packets that match the defined traffic flow of
the classifier. Permit accepts the packets. The default is Deny.
Description
Use this field to enter a description for the ACL. A description can be
up to 15 alphanumeric characters, including spaces. A description is
optional.
Port List
Use this list to specify the port where you want to assign the ACL. You
can assign an ACL to more than one port. To select multiple ports, hold
down the Ctrl key while making your selections. You do not have to
assign an ACL to a port when you initially create it. However, an ACL
that is not assigned to any port is considered inactive.
6. When you are finished configuring the parameters, click Apply.
The new ACL is immediately activated on the specified ports. If you did
not specify any ports for the ACL, the ACL is created but remains
inactive until you assign it to a port.
7. To permanently save your changes, select the Save Config menu
selection.