Allied Telesis AT-S62 - Manual (Page 249)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 249
Privacy
This option represents authentication and the privacy protocol. Select
this security level to allow authentication and encryption. This level
provides the greatest level of security. You can select this value if you
configured the Security Model parameter with the SNMPv3 protocol.
11. In the Storage Type parameter, select one of the following storage
types for this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the Target Parameters Table to the configuration file. After making
changes to a Target Parameters Table entry with a Volatile storage
type, then the Save Config menu selection does not appear.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Parameters Table to the configuration file. After making
changes to a Target Parameters Table entry with a NonVolatile storage
type, the Save Config menu selection appears.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Target Parameters Table
entry takes effect immediately.
12. Click Apply to update the SNMPv3 Target Parameters Table.
13. To save your changes, select the Save Config menu selection.
Deleting a Target
Parameters Table
Entry
To delete an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 77 on
page 246.
5. Click the circle next to the Target Parameters Table entry that you
want to delete. Then click Remove.