Allied Telesis AT-S62 - Manual (Page 160)

Chapter 14: Quality of Service
160 Section II: Advanced Operations
Classifier List
The classifier to be assigned to the flow group. The specified classifier
must already exist. You can assign more than one classifier to a flow
group. To assign multiple classifiers, hold down the Ctrl key when
making your selections.
6. Click Apply.
The changes are immediately applied to the flow group.
7. To permanently save your changes, select the Save Config menu
selection.
Deleting a Flow
Group
This procedure explains how to delete a flow group. If the flow group that
you want to delete is already part of a QoS policy that is assigned to one
or more switch ports, you must first modify the policy by removing the port
assignments before you can delete the flow group. You can reassign the
ports back to the policy after you have deleted the flow group.
To delete a flow group, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Services menu selection.
3. Select the Flow Group tab.
The Flow Group tab is shown in Figure 40 on page 156.
4. Select the flow group you want to delete and click Delete.
The flow group is deleted from the switch.
Displaying Flow
Groups
To display the flow groups on a switch, perform the following procedure:
1. From the Home Page, select Monitoring.
2. From the Monitoring menu, select the Services menu selection.
3. Select the Flow Group tab.
The Flow Group tab displays the currently configured flow groups in a
table that contains the following columns of information:
ID
The ID number for the flow group.
Description
The flow group description.