Allied Telesis AT-S62 - Manual (Page 200)

Chapter 18: Power Over Ethernet
200 Section II: Advanced Operations
Power Status
Whether power is being supplied to the device. Status will be one of
the following:
ON: Power is being supplied to a powered device.
OFF - Disabled by user: PoE is disabled on the port.
Off - Detection in process: PoE is enabled on the port, but either no
device is connected to the port or the device is not a powered device.
6. To enable or disable PoE on a port, set PoE Function to either Enable
or Disable. The default is enabled.
7. To change a port’s priority, set Power Priority to Critical, High, or
Low. A port can belong to only one priority level at a time. The default
is Low.
8. To change the maximum amount of power the port can supply to the
device, enter a new value in the Power Limit field. The value is entered
in milliwatts. The default value is 15,400 mW. The range is 3,000 to
15,400 mW.
9. After you finish setting the PoE parameters, click Apply.
Changes to a port’s PoE settings are immediately activated on the
switch.
10. To permanently save the changes, select the Save Config menu
selection.