Allied Telesis AT-S62 - Manual (Page 207)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 207
4. To enable SNMP Access, click the box next to Enable SNMP Access.
Use this parameter to enable the switch to be remotely managed with
an SNMP application program.
Note
If the check box in the Enable SNMP Access box is empty, the
switch cannot be managed through SNMP. This is the default.
5. To enable authentication failure traps to be sent on behalf of the
switch, click the box next to Enable Authentication Failure Trap.
6. Click Apply to update the User Table.
7. To save your changes, select the Save Config menu selection.