Allied Telesis AT-S62 - Manual (Page 221)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 221
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
ˆ “Creating an Access Table” on page 221
ˆ “Deleting an Access Table Entry” on page 226
ˆ “Modifying an Access Table Entry” on page 227
For reference information about the SNMPv3 Access Table, see
“Configuring the SNMPv3 Access Table” on page 221.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab. The SNMP Tab is shown in Figure 58 on page
206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page. The
SNMPv3 Access Table Page is shown in Figure 65.