Allied Telesis AT-S62 - Manual (Page 44)

Chapter 2: Basic Switch Parameters
44 Section I: Basic Operations
Rebooting a Switch
Note
Any parameters changes that have not been saved will be discarded
when a system is reset. To save parameter changes, refer to
“Saving Your Parameter Changes” on page 28.
To reboot a switch, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the General tab.
The General tab is shown in Figure 5 on page 34.
4. Click the Reset button.
A confirmation prompt is displayed.
5. Click OK to reset the switch or Cancel to cancel the procedure.
Note
The switch does not forward packets while it initializes the AT-S62
management software and loads its active configuration file. This
process takes between 20 seconds to 2 minutes to complete,
depending on the number and types of commands in the
configuration file.
Resetting the switch ends your web browser management session.
You must restart the session to continue managing the switch.