Allied Telesis AT-S62 - Manual (Page 146)

Chapter 12: Classifiers
146 Section II: Advanced Operations
Displaying the Classifiers
To display the classifiers on a switch, perform the following procedure:
1. From the Home Page, select Monitoring.
2. From the Monitoring menu, select either the Network Security or
Services menu selection. (The Classifier tab is accessible from both
menu selections.)
3. Select the Classifiers tab.
This tab lists the classifiers currently existing on the switch. The
columns are defined here:
ID
The ID of the classifier.
Description
A description of the classifier.
No. Refs. (Active)
The number of active ACLs and QoS policies to which the classifier is
currently assigned. An active ACL or QoS policy is assigned to a
switch port.
No. Refs. (Attached)
The number of active and inactive ACLs and QoS policies to which the
classifier is currently assigned. An active ACL or QoS is assigned to a
switch port, while an inactive ACL or QoS is currently not assigned to
any port.
4. To display detailed information about a classifier, select the button
next to the classifier and click View.
For definitions of the parameters, refer to “Creating a Classifier” on
page 138.
5. Click Close to close the page.