Allied Telesis AT-S62 - Manual (Page 143)

AT-S62 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 143
UDP Source Port
Defines a traffic flow by source UDP port. To set this parameter, IP
Protocol must be set to UDP.
UDP Destination Port
Defines a traffic flow by a destination UDP port. To set this parameter,
IP Protocol must be set to UDP.
User Specified Protocol
Defines a traffic flow by a protocol other than one of those listed in the
Protocol or IP Protocol list. To set this parameter, Protocol must be set
to User Specified. Alternatively, you can set this parameter if IP
Protocol is set to User Specified.
6. When you are finished configuring the parameters, click Apply.
7. To permanently save your changes, select the Save Config menu
selection.