Avery Dennison 9840 Technical Reference Manual User Manual
Page 93

MonarchNet for NetWare
5-11
Switching
following language switching options: OFF, PCL,
PostScript, or Automatic. Unless OFF is selected, a
language switching character string will be inserted
before each print job. The Printer Type selection is
used to determine the actual characters required to
switch the language of the printer. For advanced
users, the Pre/Post String setting allows custom
character strings to be added to the beginning or
end of each print job.
NOTE: Language Switching is only available in
PSERVER mode.
Printer Type
This field is used to determine the actual characters
required for your printer to switch the printer language.
If your printer type is not listed, select No Specific
Printer and then enter into the PCL or PostScript
Switch Sequence fields the required character strings
for switching your printer language.
PCL Switch
Sequence (only
available if the
selected printer
type is No
Specific Printer)
Enter the character string to switch the printer to the PCL
print language. To enter non printable characters, enclose
the ASCII value of the character in angle brackets. For
example, to enter the ESC character type: <27>.
Postscript
Switch
Sequence (only
available if the
selected printer
type is No
Specific Printer)
Enter the character string to switch the printer to the
PostScript print language. To enter non printable
characters, enclose the ASCII value of the character in
angle brackets. For example, to enter the ESC character
type: <27>.