Avery Dennison 9840 Technical Reference Manual - Manual (Page 157)

Print Server Configuration Using Telnet 8-3
The default subnet mask is 0.0.0.0. The MonarchNet interprets a subnet
mask of 0.0.0.0 or 255.255.255.255 as no subnet mask specified.
If you change the subnet mask, the change will remain undetected until the
MonarchNet is reset or is power cycled.
If you select an invalid subnet mask you may not be able
to access the MonarchNet. Use this option with care!
I d e n t i f y i n g D e f a u l t G a t e w a y I P A d d r e s s
If your local network is attached to other networks, you must specify the
address of your default gateway. Whenever packets need to be sent to
another network, the default gateway is used.
The gateway address must follow the format XXX.XXX.XXX.XXX, where
each XXX is a number between 0 and 255.
When the default gateway is changed, it will remain undetected until the
MonarchNet is reset or is power cycled.
If you select an invalid default gateway or the default
gateway goes down, the MonarchNet may not be able to
communicate with non-local networks.
Configuring
WINS
Server If you are using WINS on you network, enter the IP
Address of the WINS Server.
Configuring
SNMP for
the
MonarchNet The SNMP configuration settings allow you to configure
the MonarchNet SNMP traps. SNMP community names
and the current settings are displayed at the top of the
screen.