Avery Dennison 9840 Technical Reference Manual - Manual (Page 134)

7-16 MonarchNet for NDS
N e t w o r k P r o t o c o l s P a g e
The Network Protocols page controls which protocols are active on this
Monarch Print Server object. On this page, you can:
♦ Enable a protocol
♦ Disable a protocol
♦ Configure the TCP/IP protocol options
If you disable a protocol, the Monarch device will no longer communicate with
that protocol until it is reenabled.
To change other Monarch device configuration options use the Identification,
Assignments, Network Configuration and Port Configuration pages.
OK and Cancel affect the entire object dialog, not just this
page. Do not choose OK until you've entered all changes
on this page and other pages. If you choose Cancel, you
lose all changes in every page of this dialog.
Screen regions and buttons
Protocols Enabled allows selection of protocols to be active on the Monarch
device.
Configure TCP/IP opens a dialog where you can enter configuration settings
for the TCP/IP protocol.
Restore Defaults opens a dialog allowing the Network Protocol settings
displayed on this page, or all NetWare and port settings on all pages, to be
set back to the factory default settings. If you have insufficient rights to
modify the Monarch Print Server object properties, the Restore Defaults
button will not be available.
CAUTION
Make sure there are no print jobs active when you select
Restore Defaults. If you restore the device while a job is
printing, the job may not print successfully.
OK saves changes in all pages of this dialog.
Cancel closes this dialog without saving changes in any page.