Avery Dennison 9840 Technical Reference Manual - Manual (Page 155)

Print Server Configuration Using Telnet 8-1
P R I N T S E R V E R C O N F I G U R A T I O N
U S I N G T E L N E T
The MonarchNet Configuration utility (telnet) provides system, network and
printer status information and allows you to change the configuration of your
print server. This chapter explains how to run and exit a Telnet session.
The configuration of your print server is password
protected. Only authorized users can alter the
configuration.
On newer MonarchNet print servers, many of these
configuration options are accessible through WebView.
R u n n i n g a T e l n e t S e s s i o n
1. To run the configuration utility, type the following:
telnet
2. Replace MonarchNet_name with the IP address or the host name
assigned to the MonarchNet you want to configure.
A screen will appear displaying an introductory message. When prompted
for a password, enter MonarchNet. The password will not be echoed.
3. When you are finished typing your password, press Enter. For password
verification, you will then be asked to enter your password again.
Each time you use the utility, you will be asked to enter your password. If
you fail to enter the password correctly in three attempts, your
connection with the MonarchNet will be closed.
4. Once your password is entered and accepted, a list of options will
display. An explanation of each option follows.
8