Avery Dennison 9840 Technical Reference Manual - Manual (Page 159)

Print Server Configuration Using Telnet 8-5
Configure Port Connection (Ports 1 and 2 only) (MPX, DX, SX and MIO only)
The port connection hardware setting indicates how the MonarchNet parallel
ports are physically connected to the printer.
In most cases, the MonarchNet will be connected directly to the printer.
However, if your MonarchNet is connected to an Monarch printer-sharing
device, print jobs may not be separated properly. To ensure proper print job
separation, be sure to indicate the proper hardware configuration.
Specify
Configuration
Page
Language This option enables you to select how the MonarchNet
configuration pages should be printed: Text (default),
PCL, or PostScript.
Configure
Language
Switching This option asks you to select the language of your
printer. For a description of language switching options,
see Output Port Configuration Options.
Configure
Printer Type This option enables you to indicate the printer type to
which the MonarchNet is connected. Printer choices
are:
HP LaserJet III, IIID, IIIP w/ PostScript Plus
HP LaserJet IIISi, 4, 4M, 4Si or 4Si MX
IBM 4029, 4039
Other
Language
Switching
Sequence If you select Other, from the Configure Printer Type
screen, you must indicate the switching sequence to be
used for both PCL and PostScript. This is only
necessary if language switching is set to something
other than OFF.
Baud Rate When configuring ports for serial communication, you
must specify a baud rate for data transfer. Available
baud rates are: 9600, 19200, 38400 and 57600.
Bidirectional
Status
Support If your printer supports bidirectional capabilities and
PJL, the MonarchNet can get more detailed status from
the printer.