Avery Dennison 9840 Technical Reference Manual - Manual (Page 29)

MonarchNet for TCP/IP 1-15
C o n f i g u r i n g S N M P T r a p s
The SNMP trap options allow configuration of traps. Traps are unsolicited
information concerning the print server. Traps can be sent to an SNMP
manager or be broadcast to all hosts on the local segment. These options
only need to be configured if you are managing the Monarch print server
using SNMP.
OK and Cancel affect the entire dialog box, not just the
SNMP Traps tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.
Protocol Select the protocol for which you wish to configure trap
information.
Trap
Destination This feature allows specific traps to be sent on designated
ports to a specific destination(s). Destinations may be added
or modified up to the maximum number (one or more) allowed
for each protocol. To disable traps, delete all destinations.
TCP/IP
Protocol
Destinations Enter the IP address to which traps will be sent. The IP
address must follow the format XXX.XXX.XXX.XXX, where
each XXX is a number between 0 and 255. To broadcast
traps to all hosts on the local network, enter
255.255.255.255.
NetWare
Protocol
Destinations Enter the network number and hardware address,
respectively, to which traps will be sent. To broadcast traps
to all addresses on all networks, enter FFFFFFFF in the first
field and FFFFFFFFFFFF in the second field. To broadcast
traps to all addresses on a specific local network, enter the
network number in the first field and then FFFFFFFFFFFF in
the second field.
Ports To
Trap Select each port on which you wish traps to be active.
Printer
Traps Select each printer condition for which a trap will be sent.