Avery Dennison 9840 Technical Reference Manual - Manual (Page 167)

Windows Printer Setup 9-3
7. Select the Windows printer from which you would like to print with
MonarchNet, then select Properties from the File menu.
8. Add a MonarchNet port. This may be done by selecting Add Port under
the Ports tab.
9. From the list of Available Printer Ports, select MonarchNet IP Monitor
as the type of port to add and click New Port.
If MonarchNet is not listed, verify the software has been
properly installed.
10. You will enter into the Add MonarchNet Port screen where there will be a
list of all MonarchNet print servers available on the local subnet.
♦ The TCP/IP monitor will search only the local subnet.
♦ The IPX/SPX monitor will retrieve all devices found in the NetWare
bindery.
♦ The DLC monitor will search only the local subnet.
11. If the port you wish to add is listed in the Ports available on local subnet:
window, select the port name and click Add.
If the port you wish to use is not listed, you may:
♦ Select Cancel and repeat step 5 to rediscover the print servers.
♦ In MonarchNet Connect for IPX/SPX, click Search and enter the print
server’s Network Number and Hardware Address.
♦ In MonarchNet Connect for TCP/IP, click the Locate non-local device
button and enter the Static TCP/IP Address used for the print server.
The MonarchNet Connect for TCP/IP DHCP discovery
feature will relocate a print server on the local subnet by
its port name, even if the IP address changes. This
feature is enabled on the local subnet only. A non-local
print server will not be re-discovered if the IP address
changes.
12. Click Add.
13. Click Cancel to close the Printer Ports dialog.