Avery Dennison 9840 Technical Reference Manual - Manual (Page 145)

MonarchNet for NDS 7-27
H o w t o P r i n t w i t h a M o n a r c h P r i n t S e r v e r D e v i c e
To configure the NetWare environment for printing to a Monarch Print Server
device follow these steps:
Printing in PServer Mode:
1. Install the print server hardware and connect the cabling. (If unfamiliar
with how to do this see the Hardware Installation User’s Guide.)
2. Create an Monarch Print Server object. (If unfamiliar with how to do this
see Creating a New Monarch Print Server Object.)
3. Open the Monarch Print Server object dialog.
4. From the Assignments page, choose a port to configure.
5. Select Assign.
6. Select or Create a NetWare Printer object from the Printer/Queue
Assignments dialog.
7. Select or Create a NetWare Print Queue object from the Printer/Queue
Assignments dialog.
8. Click OK to save your printer and queue selections.
To load balance print queue jobs, repeat steps 5 through
9 for another port. Create a new printer object for the
MonarchNet port and then select the same print queue
object. This will allow multiple printers to service a single
print queue.
9. From the Assignments page, select OK to save changes to the Monarch
Print Server object.
You should now be able to submit jobs to the queue and receive jobs on the
specified printer(s).