Avery Dennison 9840 Technical Reference Manual - Manual (Page 92)

5-10 MonarchNet for NetWare
Gateway specify the address of your default gateway. This gateway
will be used whenever messages need to be sent to
another network. This gateway address must follow the
format XXX.XXX.XXX.XXX, where each XXX is a number
between 0 and 255.
CAUTION: If you select an invalid default gateway or the
default gateway becomes unavailable, the print
server may not be able to communicate with
non-local networks.
WINS
Server If you use Windows Internet Name Service (WINS), you
may enter the IP address of the WINS Server to allow
resolution of the print server's System Name on the
network.
Use DHCP
To Locate
WINS
Server Select to obtain the address of the WINS Sever from the
DHCP Server (available only if you are using DHCP to
obtain an IP address).
Password Select Password to open a dialog that allows a password
for the print server to be entered. This password is used
to configure the print server through Telnet or Http. A valid
password is from 5 to 24 characters long.
Advanced Select Advanced to open a dialog that allows configuration
of advanced TCP/IP specific settings.
C o n f i g u r i n g O u t p u t P o r t O p t i o n s
The following options are used to configure output port specific information
for your environment.
OK and Cancel affect the entire dialog box, not just the
Output Port tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.
Port Number Select the port number you wish to configure.
Name Enter a descriptive name to identify the port.
Language Each output port can be selected to perform the