Avery Dennison 9840 Technical Reference Manual - Manual (Page 56)

2-2 NetworkAlert 32
N e t w o r k A l e r t 3 2 M a i n S c r e e n
The main screen displays the alerts that have been received during this
session.
Alerts are not saved between sessions of NetworkAlert 32.
Tool Bar The tool bar is located below the menu bar. The tool bar
provides shortcuts to the most commonly used menu
commands. Place the cursor over a tool bar button to get a
tool tip about the shortcut. The tool bar can be shown and
hidden using the Tool bar option in the View menu.
Status Bar The status bar is located on the bottom of the main window.
The left side of the status bar provides help on commands.
The right side contains a count of the number of log, cache,
and view events.
N e t w o r k A l e r t 3 2 S e t u p
NetworkAlert 32 only displays events received from configured devices. To
effectively monitor your network, you must configure servers to send SNMP/IP
events. Additionally, you must select the print servers from which you wish to
receive events, and must also select which events you wish to view using the
log and view settings property sheets.
Accounting and Reporting
This release of NetworkAlert 32 supports event accounting and reporting.
Events are stored in a permanent event log, which can be used to build detail
reports based on print server activity. The report information may be exported
for further analysis or graphed using the built in graphing package.
NetworkAlert 32 uses an MDI interface, which can display several event,
report and graph views.
For more information about specific changes see “Event Log,” “Reporting,”
“Graphing,” “Device Filtering,” or “Event Filtering.”