Avery Dennison 9840 Technical Reference Manual - Manual (Page 129)

MonarchNet for NDS 7-11
Screen regions and buttons
Advertising Name displays the name Novell's NetWare Administrator uses to
communicate with the Monarch device. You cannot change this assignment.
PServer Mode Settings are only available when the Monarch device is in
PServer mode.
Queue scan time (given in tenths of seconds) indicates how often the
Monarch device will go out and look for print jobs in a print queue. You may
enter a value from 1-255 tenths of a second. The default is 40 (4 seconds).
NPrinter Mode Settings are only available when the Monarch device is in
NPrinter mode.
Print Server describes the NetWare Print Server object from which this
Monarch device receives print jobs. Browser {bmc BOX.bmp} opens a
dialog where you can select a value from a list of available NetWare Print
Server objects.
Printer/Queue Assignments allows a Printer object to be assigned to each
output port of the Monarch device. Select the port to configure in the Port #
field, then select Assign to select the Printer object and Print Queue
object(s).
To load balance print queue jobs, select a different printer
port and printer object and assign the same print queue.
Restore Defaults opens a dialog allowing the Assignments settings displayed
on this page, or all NetWare and port settings on all pages, to be set back to
the factory default settings. If you have insufficient rights to modify the
Monarch Print Server object properties, the Restore Defaults button will not
be available.
Make sure there are no print jobs active when you
select Restore Defaults. If you restore the Monarch
device while a job is printing, the job may not print
successfully.
OK saves changes in all pages of this dialog.
Cancel closes this dialog without saving changes in any page.