Avery Dennison 9840 Technical Reference Manual - Manual (Page 33)

MonarchNet for TCP/IP 1-19
Model This field displays the printer's model (i.e., HP LaserJet 4
Plus). BIDI Not Supported will be displayed if the print server
does not support bidirectional communication.
Printer Information
When turning on the printer or after sending a ^PR (printer reset) immediate
command, wait at least eight (8) seconds before sending data to the print
server. Any data sent to the print server before the 8-second interval may
be lost. For more information about immediate commands, refer to the
optional Packet Reference Manual (part number TC9800PM), available on
Monarch’s Web site.
P r i n t S e r v e r D i a g n o s t i c I n f o r m a t i o n
This screen shows information about the print server. Information on this
page cannot be altered. Select Refresh to update print server diagnostic
information.
Product
Name This field displays the name given to the print server during
configuration.
Product
Number This field displays the number identifying the print server
product.
Serial
Number This field displays the serial number located on the print
server enclosure.
H/W
Address This field displays the Ethernet/Token-Ring address
assigned at the factory.
Cable
Type This field displays the type of network cabling used to
connect the print server to the network.
Date Code This field displays the date code which identifies the
firmware.
F/W
Version This field displays the version of firmware on the print
server.
MIB
Version This field displays the version of the Monarch private MIB
that the print server supports.
Net Speed This field displays the speed at which the print server is
running.