Avery Dennison 9840 Technical Reference Manual - Manual (Page 19)

MonarchNet for TCP/IP 1-5
C o n f i g u r i n g T C P / I P O p t i o n s
The following options are used to configure the print server's TCP/IP-specific
settings for your environment.
OK and Cancel affect the entire dialog box, not just the
TCP/IP tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.
IP Address Resolution
Set
Permanent Select this option to make the IP address permanent. If the
print server has been configured to remember its IP
address, it does not need to determine its address each time
it is powered on.
Enter the print server's IP address. The IP address must
follow the format XXX.XXX.XXX.XXX, where each XXX is a
number between 0 and 254.
CAUTION: If you select an invalid IP address, you may not
be able to access the print server.
Use
Network
Protocol Select this option to use RARP, BOOTP or DHCP to
determine the IP address at power up. Specify which
protocol(s) to use.
Subnet
Mask If your network environment includes subnets, you will want
to set the subnet mask.
The subnet mask must follow the format
XXX.XXX.XXX.XXX, where each XXX is a number between
0 and 255. The default subnet mask is 0.0.0.0. The print
server interprets a subnet mask of 0.0.0.0 or
255.255.255.255 as no subnet mask specified.
CAUTION: If you select an invalid subnet mask, you may
not be able to access the print server.