Avery Dennison 9840 Technical Reference Manual - Manual (Page 27)

MonarchNet for TCP/IP 1-13
Postscript Switch
Sequence (only
available if the
selected printer type
is No Specific Printer) Enter the character string to switch the printer to the
PostScript print language. To enter non printable
characters, enclose the ASCII value of the character
in angle brackets. For example, to enter the ESC
character type: <27>.
Configuration Page
Language Select the appropriate printer language for printing
configuration pages on your printer (Text, PCL,
PostScript or Off). The Off option, if available, will
prevent configuration pages from being printed on
the selected port.
WARNING:The Configuration Page Language value
should never be set to Off for all ports of
the print server. At least one port should
contain a language setting to allow a
configuration label to be printed as
needed for diagnostic/troubleshooting
purposes.
Output Type Select the appropriate baud rate or setting.
Bidirectional Printer
Status Support Bidirectional Printer Status Support enables the
Monarch print server to get printer status
information. The printer attached to the output port
must support bidirectional communication and PJL.
Disable this option if the printer attached does not
support bidirectional communication or PJL.
C o n f i g u r i n g S N M P O p t i o n s
The SNMP options specify information necessary for an SNMP manager to
access the print server.
OK and Cancel affect the entire dialog box, not just the
SNMP options. Do not choose OK until you've entered all
changes on this tab and other tabs. If you choose Cancel,
you lose all changes in every tab of this dialog box.