Avery Dennison 9840 Technical Reference Manual - Manual (Page 18)

1-4 MonarchNet for TCP/IP
3. Configure the print server.
Select the Configuration option from the Print Server menu. You will be
prompted to enter the IP address for this print server. Once this is done,
the full configuration will be displayed. Choose the applicable file folder
tab and make any modifications to configure the print server for your
environment. Select OK when done.
The print server should be ready to accept print jobs!
C o n f i g u r i n g a P r i n t S e r v e r
The print server must be given an IP address before it can be configured. If
the print server does not have an IP address, you will be prompted to enter
one.
Once a print server has an IP address, it can be configured to change any
settings necessary. Settings are grouped into the following categories:
♦ TCP/IP
♦ NetWare
♦ NetWare Queues
♦ NetWare Port
♦ Output Port
♦ SNMP
♦ Protocols
♦ SNMP Traps
♦ Token-Ring
These settings can be accessed by selecting the Configuration option from
the Print Server menu or by selecting the Telnet option from the Tools menu.
Follow the menus to change any settings necessary.
If the print server does not support the SNMP private
MIB, a simple Telnet configuration utility will be started
when Configure is selected.