Avery Dennison 9840 Technical Reference Manual - Manual (Page 176)

9-12 Windows Printer Setup
11. If the port you wish to add is listed in the Ports available on local subnet
window, select the port name and click the Add button.
If the port you wish to use is not listed, you may:
♦ Select Cancel and repeat step 5 to rediscover the print servers.
♦ In MonarchNet for IPX/SPX, click Search and enter the print server’s
Network Number and Hardware Address.
♦ In MonarchNet for TCP/IP, click the Locate non-local device button and
enter the Static TCP/IP Address used for the print server.
The MonarchNet for TCP/IP DHCP discovery feature will
relocate a print server on the local subnet by its port
name, even if the IP address changes. This feature is
enabled on the local subnet only. A non-local print server
will not be re-discovered if the IP address changes.
12. Click Add.
13. Click OK to save the configuration.
You will now be able to use MonarchNet. Whenever you print to the Windows
printer configured with MonarchNet, your print job will go directly to the
MonarchNet print server port.
Port Settings
If you have printing problems while using the MonarchNet Connect printing
port, you may check the status of the port by selecting Port Settings under
the Details tab in the Properties screen.
♦ For Windows 95/98, select Port Settings under the Details tab.
♦ For Windows NT 4.0 or Windows 2000, select Configure Port under the
Ports tab.
♦ For Windows NT 3.51, select Settings.