Avery Dennison 9840 Technical Reference Manual - Manual (Page 172)

9-8 Windows Printer Setup
11. If the port you wish to add is listed in the Ports available on local subnet:
window, select the port name. If the port you wish to use is not listed,
you may:
♦ Select Cancel and repeat step 5 to rediscover the print servers.
♦ In MonarchNet for IPX/SPX, click Search and enter the print server’s
Network Number and Hardware Address.
♦ In MonarchNet for TCP/IP, click the Locate non-local device button and
enter the Static TCP/IP Address used for the print server.
The MonarchNet for TCP/IP DHCP discovery feature will
relocate a print server on the local subnet by its port
name, even if the IP address changes. This feature is
enabled on the local subnet only. A non-local print server
will not be re-discovered if the IP address changes.
12. Click Add.
13. Click OK to save the configuration.
You will now be able to use MonarchNet. Whenever you print to the Windows
printer configured with MonarchNet, your print job will go directly to the
MonarchNet print server port.
U s i n g t h e W i n d o w s N T 3 . 5 1 L P R P r i n t M o n i t o r
A Microsoft LPR print monitor is shipped with Windows NT. This print monitor
is not included in the default Windows NT installation, therefore, it will need
to be installed. In order to set up an LPR printer in Windows NT, the system
must have an IP address, the print server must have an IP address, and
Microsoft TCP/IP printing must be installed.
System Requirements
♦ Administrator privileges
♦ Windows NT installation disks or CD