Avery Dennison 9840 Technical Reference Manual - Manual (Page 85)

MonarchNet for NetWare 5-3
Installing a new print server using MonarchNet for NetWare requires three
steps:
1. Connect the print server to the network.
Connect the network cable to the print server. Make sure that the print
server is on the same local network as the workstation that is running
this utility.
2. Select the print server from the list.
Run MonarchNet for NetWare utility by selecting MonarchNet for
NetWare from the Monarch Printing group. Select the print server from
the list. By default, the All Print Servers view is selected and all print
servers attached to the network from which the MonarchNet utility is
running are listed.
If the print server is not in the list, select the Unconfigured Print
Servers view. If MonarchNet for NetWare was already running before the
print server was installed, select the Refresh option from the View menu.
If the print server is still not in the list, select Search from the Tools
menu and enter the network number and hardware address of the device.
3. Configure the print server.
Select the Configuration option from the Print Server menu. The full
configuration will be displayed. Make any modifications to configure the
print server for your environment. Select OK when done.
The print server should be ready to accept print jobs!
C o n f i g u r i n g a P r i n t S e r v e r
Print Server configuration settings are grouped into the following categories:
♦ NetWare
♦ TCP/IP
♦ Output Port
♦ SNMP
♦ Protocols
♦ SNMP Traps
♦ Token Ring