Avery Dennison 9840 Technical Reference Manual - Manual (Page 174)

9-10 Windows Printer Setup
5. From the Add LPR Compatible Printer window, enter the print server’s IP
address or name (if you are using DNS or WINS) for the host name
prompt.
6. Enter a number indicating the desired print server’s output port for the
printer name prompt and click OK. For example, for port 1 enter P1, for
port 2 enter P2, etc.
7. Click OK from the Create Printer window to add the printer.
M o n a r c h N e t C o n n e c t f o r T C P / I P
MonarchNet Connect for TCP/IP is a fully featured utility that allows simple,
direct, TCP/IP printing from your computer to a printer attached to an
Monarch TCP/IP enabled print server. With MonarchNet Connect, you can
even print to print servers using Dynamic IP addresses (DHCP). Print jobs
printed through MonarchNet Connect are sent directly to the MonarchNet
print server and not routed through the network server, resulting in a
reduction of network traffic.
The DHCP feature of MonarchNet for TCP/IP will
rediscover a print server on the local subnet, even when
its IP address may be changing (e.g. when using DHCP
for IP address resolution). The print server will be
relocated by its port name as configured through the
MonarchNet Utility (default name is Serial Number-Port
Number). This feature is enabled on the local subnet only.
A non-local print server will not be re-discovered if the IP
address changes.
System Requirements
To use MonarchNet Connect for TCP/IP, your operating system must be
Windows 95 or Windows 98 and your computer must be configured to run
TCP/IP. The MonarchNet print server must also be configured to run TCP/IP.