Avery Dennison 9840 Technical Reference Manual - Manual (Page 20)

1-6 MonarchNet for TCP/IP
Default
Gateway If your network is attached to other networks, you should
specify the address of your default gateway. This gateway
will be used whenever messages need to be sent to another
network. This gateway address must follow the format
XXX.XXX.XXX.XXX, where each XXX is a number between 0
and 255.
CAUTION: If you select an invalid default gateway or the
default gateway becomes unavailable, the print
server may not be able to communicate with non-
local networks.
WINS
Server If you use Windows Internet Name Service (WINS), you may
enter the IP address of the WINS Server to allow resolution
of the print server's System Name on the network.
Use DHCP
To Locate
WINS
Server Select to obtain the address of the WINS Sever from the
DHCP Server (available only if you are using DHCP to
obtain an IP address).
Password Select Password to open a dialog that allows a password for
the print server to be entered. This password is used to
configure the print server through Telnet or Http. A valid
password is from 5 to 24 characters long.
Advanced Select Advanced to open a dialog that allows configuration of
advanced TCP/IP specific settings.
C o n f i g u r i n g N e t W a r e O p t i o n s
The following options are used to configure the print server's NetWare-
specific settings for your environment.
OK and Cancel affect the entire dialog box, not just the
NetWare tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.