Avery Dennison 9840 Technical Reference Manual - Manual (Page 161)

Print Server Configuration Using Telnet 8-7
R e s t o r i n g t o F a c t o r y D e f a u l t C o n f i g u r a t i o n
This option automatically restores the MonarchNet to its original factory
defaults. Be aware that when you restore the MonarchNet to the original
factory default settings, only the TCP/IP protocol and output port information
is restored and your TCP/IP password and IP address are erased.
CAUTION
Make sure that no print jobs are active when you select
Restore to Factory Defaults. Performing this operation
will restore parameters for the TCP/IP protocol to factory
defaults. If you reset the MonarchNet while a job is
printing, the job may not print successfully.
E n a b l i n g / D i s a b l i n g P r o t o c o l
This option allows you to disable other protocols on the MonarchNet. It will
give you a list of the other protocols on the MonarchNet and their current
status (enabled or disabled).
E x i t i n g T e l n e t
When you are satisfied the MonarchNet is configured correctly, press Enter
to exit the utility. If you changed the configuration or password, you will be
prompted to save your changes. Type Y and press Enter. Press Enter alone
to exit without saving the changes you made.
CAUTION
If changes are saved, all protocols will be reset. If you
reset the MonarchNet while a job is printing, the job may
not print successfully.