Avery Dennison 9840 Technical Reference Manual - Manual (Page 91)

MonarchNet for NetWare 5-9
RPRINTER/NPRINTER Mode Settings
Printer
Number Enter a printer (0 - 15) for the port. NetWare 4.X supports
printer numbers 0 - 254.
C o n f i g u r i n g T C P / I P O p t i o n s
The following options are used to configure the print server's TCP/IP-specific
settings for your environment.
OK and Cancel affect the entire dialog box, not just the
TCP/IP tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.
IP Address Resolution
Set
Permanent Select this option to make the IP address permanent. If
the print server has been configured to remember its IP
address, it does not need to determine its address each
time it is powered on. Enter the print server's IP address.
The IP address must follow the format
XXX.XXX.XXX.XXX, where each XXX is a number
between 0 and 255.
CAUTION: If you select an invalid IP address, you may
not be able to access the print server.
Use
Network
Protocol Select this option to use RARP, BOOTP or DHCP to
determine the IP address at power up. Specify which
protocol(s) to use.
Subnet
Mask If your network environment includes subnets, you will
want to set the subnet mask. The subnet mask must follow
the format XXX.XXX.XXX.XXX, where each XXX is a
number between 0 and 255. The default subnet mask is
0.0.0.0. The print server interprets a subnet mask of
0.0.0.0 or 255.255.255.255 as no subnet mask specified.
CAUTION: If you select an invalid subnet mask, you may
not be able to access the print server.
Default If your network is attached to other networks, you can