Avery Dennison 9840 Technical Reference Manual - Manual (Page 26)

1-12 MonarchNet for TCP/IP
C o n f i g u r i n g O u t p u t P o r t O p t i o n s
The following options are used to configure output port specific information
for your environment.
OK and Cancel affect the entire dialog box, not just the
Output Port tab options. Do not choose OK until you've
entered all changes on this tab and other tabs. If you
choose Cancel, you lose all changes in every tab of this
dialog box.
Port Number Select the port number you wish to configure.
Name Enter a descriptive name to identify the port.
Language
Switching Each output port can be selected to perform the following
language switching options: OFF, PCL, PostScript, or
Automatic. Unless OFF is selected, a language switching
character string will be inserted before each print job. The
Printer Type selection is used to determine the actual
characters required to switch the language of the printer.
For advanced users, the Pre/Post String setting allows
custom character strings to be added to the beginning or
end of each print job.
Language Switching is only available in PSERVER mode.
Printer Type This field is used to determine the actual characters
required for your printer to switch the printer language. If
your printer type is not listed, select No Specific Printer and
then enter into the PCL or PostScript Switch Sequence
fields the required character strings for switching your
printer language.
PCL Switch
Sequence
(only available
if the selected
printer type is
No Specific
Printer) Enter the character string to switch the printer to the PCL
print language. To enter non printable characters, enclose
the ASCII value of the character in angle brackets. For
example, to enter the ESC character type: <27>.