External control interfaces – Lab.gruppen PLM 20K44 User Manual
Page 293
288
Lake Controller Operation Manual Rev 1.5.4
External Control Interfaces
▸
Preset Store (not applicable for MY8-LAKE)
▸
Adjustment of amplifier gain and Voltage Peak Limiter (Lake-enabled Amplifiers only)
▸
Activation of LoadPilot on individual power output channels (PLM+ and D Series only)
▸
Activation of data transmission for amplifier output voltage and current via Dante (Lake-enabled Ampli-
fiers only
Additionally, the following parameters may be retrieved from all devices (except MY8-LAKE) using the DLM
Protocol:
▸
Preset Name, Firmware Version, Unique ID and Mac Address
▸
IP Address and Subnet Mask
▸
Dante Break-In and Enable Status
▸
Input Activity and Configuration
▸
Metering and Fault Information
▸
Current DSP > Amp Routing (Lake-enabled Amplifiers only)
▸
Output channel Impedance Measurement in Ohms (PLM+ and D Series only)
These external control systems must form valid Ethernet packets that follow the requirements of the
network packet specification. Please email [email protected] to obtain the information required
for integration.