Lab.gruppen PLM 20K44 - Manual (Page 143)

138
Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
To connect/disconnect an input, tap the button labeled ON/OFF or drag the fader. The total Module input
mix is shown on the far right of the Input Mixer window.
For Dante inputs, the receiver input channel label is displayed below the ON button.
Input +4dBu Button
Tap the INPUT +4dBu button to view the physical input signal meter relative to +4 dBu. Tap the button again
to return to the default Digital Clip (DClip) view.
The DClip metering mode shows the audio level prior to any gain adjustment (input headroom, or digital gain
offset), and indicates when the A/D converters will clip. The +4 dBu metering mode shows the audio level
after any gain adjustment, and is useful for comparing levels of different input signals prior to processing.
This is a global function; all physical input meters throughout the system display the reference selected here.
Auxiliary Input Toggle Switch
An auxiliary channel is available on the following Module types:
▸ Classic 2-Way + 1-Auxiliary Outputs (CL2w+1a)
▸ Classic 3-Way + 1-Auxiliary Outputs (CL3w+1a)
▸ Linear Phase Classic 2-Way + 1-Auxiliary Outputs (LP2w+1a)
The interactive block diagram for these Modules types looks similar to that shown in Figure 8-21.
Figure 8-21: 2-Way + 1-Auxiliary Outputs Block Diagram and Input Mixers
These Module types provide a separate input selector for the auxiliary channel. This allows the auxiliary
channel to be sourced independently of the crossover, or from the same post-input EQ signal.