Lab.gruppen PLM 20K44 - Manual (Page 228)

Lake Controller Operation Manual Rev 1.5.4
Designer Mode Menu Reference
223
Table 19-1: Designer Mode Security Examples
SCENARIO NAVIGATE TO
Factory Levels
Locked
Levels > Meter Options
The Adjust Factory button normally present is not
available until the base configuration file is unlocked.
Level Limits
Locked
Levels > Meter Options
The Level Limits button normally present is not available
until the base configuration file is unlocked.
The Input Delay
Max Level Limit is
set to zero.
Levels > Delay
Attempt to move the input delay fader, shown in
Designer Mode only. (In User Mode, this delay fader is
removed.)
XOVER/HPF/LPF
transferred and set
to View Only
EQ > XOVER (or HPF/LPF)
EQ is affecting the
audio, but cannot be
viewed
PEQ and GEQ settings stored in base configuration files
cannot be viewed, although an audio comparison can
be made between Module A and B to verify they are
identical.
19.2.1.5 Summary
Base configuration files enable low-level security allowing control over individual aspects of the system. The
system designer can fine-tune a speaker configuration or system EQ and protect the settings by hiding or
setting them as View Only.
The base configuration files can be stored and recalled into other Modules in the same system or in differ-
ent systems. This provides a starting point from which the Module can be fine-tuned by another designer or
user.
The I/O CONFIG screen displays the name of the
base configuration file that was originally recalled or
most recently stored. I/O CONFIG is located under
the MODULES menu.