ADS Environmental Services Profile Software 950015B6 User Manual

Page 91

Profile Main Screen

2-51

CONFIDENTIAL – Covered by ADS Software License Agreement

• Rain Alarm Set up the following parameters when you want

the FlowShark monitor (equipped with a rain gauge) to send
out an alarm to an IntelliServe system when specific rain
conditions occur at the monitor.



Enable Select this checkbox to enable the Rain Alarm
function using the conditions specified in the Rain Alarm
Threshold and Return to Normal fields.



Threshold Enter the rainfall that must occur over a
specified interval (designated in the Rain Gauge device
property window) for the monitor to contact the ADS
IntelliServe system to initiate a rain alarm.



Return to Normal Enter the rainfall amount that must
occur over a specified interval (designated in the Rain
Gauge device property window) for the monitor to contact
the ADS IntelliServe system to discontinue alarm
conditions.

• Low Flow Alarm Configure the Low Flow Alarm

parameters when you want the FlowShark monitor to send out
an alarm to an ADS IntelliServe system when low flow
conditions occur at the monitor based on either a Daily Flow
Pattern or a Daily Depth Pattern.



Threshold Type Select the flow condition you want to
use as the threshold for the low flow alarms.

− Daily Flow Pattern Choose this option to trigger an

alarm when the flow rate calculated by the monitor
falls below the threshold of typical flow rates. The
monitor accommodates the different day types
(weekday or weekend) and time of day when
reviewing the threshold.

− Daily Depth Pattern Choose this option to trigger

an alarm when the flow depth level measured by the
monitor falls below the threshold of typical depth
levels. The monitor accommodates the different day
types (weekday or weekend) and time of day when
reviewing the threshold.