Analog output card device – ADS Environmental Services Profile Software 950015B6 User Manual

Page 70

2-30

Profile Software User's Guide

CONFIDENTIAL – Covered by ADS Software License Agreement

• Resistor Value Enter the nominal value in ohms for the

4/20 mA circuit.

• Min Input Enter the value you want to serve as the minimum

cutoff value for the input. If a reading falls below this setting,
this value will be recorded in place of the actual reading.

Analog Output Card Device

Edit the analog output card device in the following way:

Note: The following instructions apply to all ADS
monitors using an analog input device except FlowShark
monitors. For instructions on editing an analog input
device associated with a FlowShark monitor, refer to
Analog Output Card Device (FlowShark) on page 2-31.

Edit Analog Output Device Properties

• Enable Select the checkbox corresponding to the channel for

which you want to set up parameters.