ADS Environmental Services Profile Software 950015B6 User Manual

Page 285

6-14

Profile Software User's Guide

CONFIDENTIAL – Covered by ADS Software License Agreement

 Serial Port Select the proper port for serial communication

from this drop-down list. This list should include all available
ports on your computer.

 DMI Port Select the proper port for communication using

the DMI cable from this drop-down list. This list should
include all available ports on your computer.

 Timeout Enter the number of seconds you want your local

computer to wait for a response from the monitor once
communication has been initiated. (Default value is 80.)

 Retries Enter the number of times you want your local PC

to request data from the monitor following failed attempts
while the monitor is still on line. (Default value is 3.)

 Low Temperature Enter the temperature reading from the

monitor, ultrasonic depth sensor, and pressure depth sensor
below which you want Profile to provide notification.
(Default value is 32

° F.)

 High Temperature Enter the temperature reading from the

monitor, ultrasonic depth sensor, and pressure depth sensor
above which you want Profile to provide notification.
(Default value is 120

° F.)

 Log Communications Select this checkbox to record all

communication activities with the monitor.

 Status on Connect Select this checkbox to view details of

the current state of the monitor when monitor communications
are established. If you do not want to view the monitor status
details at connect, do not select this checkbox.

 Low Battery Enter the voltage below which you want

Profile to provide notification for each designated monitor
series. ADS recommends leaving the default battery settings
unchanged.

Note: Notification of low battery voltage or signal strength
occurs during the data collection process, during monitor
activation, and when receiving TCP/IP communication status.