ADS Environmental Services Profile Software 950015B6 - Manual (Page 489)

Final Data Generator 14-9
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
Choosing to Calculate Data Dependencies
Select the Calculate Dependencies checkbox when you want to
generate dependent data immediately after generating the
AVGUDEPTH data entity.
Creating Table Entries
The Selected Entities table, located at the bottom of the Final Data
Generator dialog, is a list of the selected data entities and time
spans used to develop the AVGUDEPTH data entity. Select a
single or combine multiple depth data entities from the Available
Entities list for each entry to the Selected Entities table.
Generate AVGUDEPTH by performing the following steps:
1. Select the desired depth data entity (or entities you want to
combine) to represent AVGUDEPTH from the Available
Entities list.
Note: Select multiple entities from the Available Entities
list by holding down the button while selecting the
entities from the list.
2. Enter the date you want to begin using the selected depth entity
(or entities) into the Start Date/Time field.
3. (Optional) Add, subtract, divide, or multiply any factor to
adjust the final AVGUDEPTH data entity by entering the
value by which you want to adjust the AVGUDEPTH entity to
the Factor field and then selecting the type of mathematical
operation (add, subtract, divide, or multiply) to perform on the
data from the Factor Op drop-down list.
4. Select the Avg button to add the entry to the table.
Note: It is possible to make a single entry to the Selected
Entities table that will always represent the
AVGUDEPTH data entity.