ADS Environmental Services Profile Software 950015B6 - Manual (Page 226)

4-4 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
When to Use the Quantity Coefficient
Generator
The Quantity Coefficient Generator typically is used during the
project setup phase, simultaneously with the Installation
Generator, for any monitoring point for which you want to
generate depth-based Manning and/or Colebrook-White flow
quantities. Use the Quantity Coefficient Generator to solve for
the Hydraulic Coefficient (HC) used in the Manning or the
roughness and slope coefficients used in the Colebrook-White flow
equations.
Refer to the project life cycle in the Introduction section for more
information.