ADS Environmental Services Profile Software 950015B6 - Manual (Page 490)

14-10 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
Each entry is added chronologically to the Selected Entities table.
5. Continue adding entries to the table, as necessary, until you
have specified the entire time period for which you want to
generate AVGUDEPTH.
Setting the Value of AVGUDEPTH
Use the Set button to assign a specific value to each
AVGUDEPTH data point by performing the following steps:
1. Enter the value you want to assign to AVGUDEPTH into the
Factor field.
2. Select the "+" or "-" symbol from the Factor Op drop-down
list to distinguish the value as positive or negative.
3. Enter the date you want to begin applying the value to the
AVGUDEPTH entity into the Start Date/Time field.
4. Select the Set button.
When AVGUDEPTH generates, it will equal the Factor for the
specified time span.
Deleting AVGUDEPTH Table Entries
Delete a single entry from the Selected Entities table by
highlighting the entry from the table and selecting the Delete
button. Delete multiple entities from the Selected Entities table by
holding down the button while selecting entities from the
list you want to delete and then selecting the Delete button.
Delete all entries from the table by selecting the Delete All button.
Generating AVGUDEPTH
Go
button
After adding all necessary entries to the Selected Entities table for
AVGUDEPTH, specify the time span for which you want to
generate AVGUDEPTH in the Calc Start and Calc End fields and
select the Go toolbar button to generate AVGUDEPTH.