ADS Environmental Services Profile Software 950015B6 - Manual (Page 143)

Profile Main Screen 2-103
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
automatically optimize the amplification of the signal.
Select the Manual option to enter a fixed value between -
12dB (lower amplification) and +12dB (higher
amplification).
 Ping Amplitude Choose the method for managing the
amplification of the analog signal that is sent out, or
transmitted from, the sensor. Smaller pipes typically
require lower (quieter) amplitude, values while larger pipes
typically need stronger (louder) amplitudes. Select the
Auto (default) option to allow the monitor to automatically
optimize the amplification of the signal. Select the Manual
option to enter a percentage of full amplification at which
to transmit the signal. Enter a percentage between 10 and
100 (where 100 represents maximum amplification).
Pressure tab
Surface Combo Device
• Enable Select this checkbox to ensure the monitor begins
taking pressure depth readings at the designated interval once
activated.
• Electronic Offset Enter the difference that exists between
the pressure depth readings and the value equal to the pipe
height minus the physical offset of the Surface Combo Sensor.
However, ADS recommends leaving this value at zero.
• Store Data Select this checkbox to ensure the monitor logs
the pressure data to memory. This option is selected by
default.
Temperature tab Surface Combo Device
• Sensor Select the source from which to measure the
temperature used when compensating for temperature in
Surface Combo Sensor readings. The channels correspond to
the sensors connected to those channels (ports) on the
monitor. The option selected here should be consistent with
the option selected for the Channel in the Device Parameters
section at the bottom of the dialog.
Note: The stored temperature value is the actual air
temperature reading from the Surface Combo Sensor.