ADS Environmental Services Profile Software 950015B6 User Manual

Page 66

2-26

Profile Software User's Guide

CONFIDENTIAL – Covered by ADS Software License Agreement

Edit Devices

Note: The sensor devices listed in Available Devices
vary depending on the monitor series currently selected.

4. Select the monitoring point to which you want to assign the

devices from the Monitoring Point drop-down list.

5. Select the checkboxes corresponding to the devices you want to

assign to the designated monitoring point from the Available
Devices selection box. A checkmark must display beside a
device in the Monitoring Point Devices section to ensure
Profile includes the device in the LIF. Deselect the
checkboxes from the Available Devices section corresponding
to the devices you want to remove from association with the
selected monitoring point.

Note: Some monitors allow you to connect two of the
same device type to the monitor at one time. Therefore,
the Available Devices list may include two of each device
type (e.g., Peak Combo 1 and Peak Combo 2), except for
the Modem Setup device. However, do not assign two
devices of the same type to the same monitoring point. For
FlowShark Triton and FlowHawk

™

monitors, this will

cause the monitor to overwrite the new data corresponding
to one of the duplicate devices with the data from the other