ADS Environmental Services Profile Software 950015B6 User Manual

Page 90

2-50

Profile Software User's Guide

CONFIDENTIAL – Covered by ADS Software License Agreement

the High High Depth Alarm Threshold and Return to
Normal fields.



Threshold Enter the flow depth above which you want
the monitor to contact the IntelliServe system to initiate a
High High Depth alarm. This value must be zero when
not in use or at least 2 inches greater than the value entered
for the High Threshold when it is in use.

Note: To prevent potential false alarms, input a value
greater than 1 into the Readings to Average field of the
Unidepth Averaging section.



Return to Normal Enter the flow depth below which
you want the monitor to send a message to the ADS
IntelliServe system indicating the high, high depth
conditions no longer exist at the monitor.

• Low Depth Alarm Set up the following parameters when

you want the FlowShark monitor to send a Low Depth Alarm
message to an ADS IntelliServe system when specific low
flow depth conditions occur at the monitor.



Enable Select this checkbox to enable the Low Depth
Alarm function using the conditions specified in the Low
Depth Alarm Threshold and Return to Normal fields.



Threshold Enter the flow depth below which you want
the monitor to contact the ADS IntelliServe system to
initiate a Low Depth alarm. This depth should be lower
than the lowest depth that commonly occurs at the
location.

Note: To prevent potential false alarms, input a value
greater than 1 into the Readings to Average field of the
Unidepth Averaging section.



Return to Normal Enter the flow depth at which you
want the monitor to send a message to the ADS
IntelliServe system indicating the low depth conditions no
longer exist at the monitor.