NavCom Sapphire Rev.J - Manual (Page 363)

Sapphire Technical Reference Manual Rev. J
363
2.101 SDCARD (ASCII)
SF-3050 Sapphire SF-3040
This message is used to report events associated with the SF-3050 internal SD flash and the
SF-3040 removable SD card. It can be scheduled as an OnChange output message for a
specific port and turned off using the [OUTPUT] command.
Table 190: SDCARD Output Messages for the SF-3040
Message Event
PRESENT
Indicates the SD card is present in the receiver
when the unit is powered on
REMOVED Indicates the SD card is not present in the
receiver when the unit is powered on or that the
SD card has been removed
INSERTED Indicates the SD card has been inserted
LOCKED Indicates the SD card is write-protected
UNLOCKED Indicates the SD card is not write-protected
REMOVED WHILE
LOGGING DATA Indicates the SD card was removed while data
logging was in progress
MOUNTED Indicates the SD card mounted successfully
MOUNTING FAILED Indicates mounting of the SD card failed
MOUNTING…5
(numeral varies) This message, triggered by the user commands
[LOGFILE] and [FSFORMAT] indicates that
mounting is in progress; the numeral indicates
the mounting time in seconds
Table 191: SD FLASH Output Messages for the SF-3050
Message Condition
MOUNTED Indicates the SD flash mounted successfully
MOUNTING
FAILED Indicates mounting of the SD flash failed
MOUNTING…5
(numeral
varies) This message, triggered by the user commands
[LOGFILE] and [FSFORMAT], indicates that mounting is
in progress; the numeral indicates the mounting time in
seconds
Examples:
The following apply to the SF-3040 only:
If an SD card is present when the unit is powered on, the following [SDCARD] message
is output:
[SDCARD] PRESENT
If an SD card is not present when the unit is powered on, the following [SDCARD]
message is output: